Newsletters>
Prototype 3 Plans and Articles

July 5, 2007

The design phase for the Prototype 3 rim lathe is well 
under way. I have established a special area on the website 
that is dedicated to articles and plans for Prototype 3. 
 
Here is the link to the list of articles: 
http://www.hicklerbanjo.azbestvalue.com/page/page/4718858.htm 
 
If the link does not work, go to the articles (accessible 
from a button on any page at the left side of the screen) 
section and select the top article. 
 
So far I have put up two new articles: plans for the new 
modular base and an article about cross slides. 
 
If you have questions, please post them on the bulletin 
board forum so that the whole rim lathe community will 
benefit from the discussion. 
 
Thanks, 
- Mark